Tri copter kits full#

It’s easy to travel with, yet offer very long flight times previously only possible with much larger rigs. We have put together a super efficient electronics pack for the Tricopter LR that, with the right battery and a light build, makes it possible to achieve over an hour of hovering flight time! We are really happy with how this copter turned out. That is weight saved that can go towards battery capacity, which together with the higher efficiency of the motors, low weight and low drag frame equal a lot of flight time. The recommended 1600kV 2207 motors weigh less than half of the motors previously used on the Tricopter V4, yet they are more efficient.

Tri copter kits full#

The Tricopter LR is designed to take full advantage of this, using 3S (for long flight time) or 4S (for bonkers flying). The 6S battery trend on mini quads has lead manufacturers to make lower kV motors in the same small form factor. This was no small feat on a copter swinging 8″ propellers on such a compact frame. We went to great lengths to make sure that no props are visible in the image (when using the recommended setup). The tricopter LR uses the standard 30.5mm hole mounting pattern used by most flight controllers which offer flexibility. It’s easily transported as the front arms can be folded back (no tools needed!).ĭespite being compact it has a lot of room for electronics and FPV equipment inside of the frame. It swings 8″ propellers to get high efficiency and QUIET flights. This copter is all about long range and long flight time. The next chapter in the tricopter saga starts now! We are proud to present the Tricopter LR! We hope you’ve enjoyed the ride as much as we have. Here are some example pictures:Ī big thank you to all of you for the support you have given us. It might be a tight fit in some cases, but with some cable management, you should be able to get it in there. The board will still fit in the Tricopter LR, Baby Tricopter and Bicopter. The board offers many great additional features but comes at the cost of being slightly larger. We suggest getting the Mateksys PDB FCHUB-W board as a replacement.

We have already run out of our in-house designed Baby PDB, a power distribution board specifically made to power servos. We will be offering the custom BMS210 servos with feedback wire for as long as we sell kits in the store. Good news is that we will continue selling kits and parts for a while longer so there will be time to pick up spare parts, or get a kit, and source your own electronics. This will be the first step in closing down the RCExplorer webshop. Once the electronics we have in stock are sold they will no longer be available to purchase on our site. Starting from today, we will no longer be restocking electronics in the shop.